Handset accessories

You must remove the battery pack before you can remove or install the MEM card. Reinstall the battery pack after you remove or install the MEM card. The MEM card tray is under the battery pack on the back of the handset.

Extracting the MEM card from the frame

To install the MEM card into the handset, you must extract it from the frame.

Attention: A new MEM card is delivered in a larger frame; use the following procedure to remove it from the frame before you install it into the handset.

To extract the MEM card from the frame, perform the following step:

1.Remove the MEM card from the frame as shown in the following figure.

Figure 25: Extracting the MEM card from the frame

Attention: When you remove the MEM card from the frame, do not touch the metal contacts.

Installing the MEM card

To install the MEM card in the handset, perform the following steps:

1.Place the handset face down on a flat surface.

2.Remove the battery compartment cover and the battery.

Note: For information about removing the DECT 4027 or 4070 handset battery compartment cover, see “Installing the battery pack (4027 and 4070 only)” (page 18).

223

Page 223
Image 223
Nortel Networks 4075 manual Extracting the MEM card from the frame