106 Configuring the domain
Because of the amount of traffic generated, Nortel recommends that you
set up syslog on the backend server if possible.
A syslog message generated on a Nortel SNAS device looks like the
following:
Mar 8 14:14:33 192.168.128.24 <ISD-SSL>:
192.168.128.189 TLSv1/SSLv3 DES-CBC3-SHA "GET / HTTP/1.0".
To set up a syslog server to receive UDP syslog messages for all HTTP
requests handled by the portal server, use the following command:
/cfg/domain #/server/adv/traflog
The Traffic Log Settings menu appears.
The Traffic Log Settings menu includes the following options:
/cfg/domain #/server/adv/traflog
followed by:
sysloghost <IPaddr> Specifies the IP address of the syslog server.
udpport <port> Specifies the UDP port number of the syslog
server.
•port is an integer in the range 1–65534 that
indicates the UDP port number. The default is
514.
priority debug|info|
notice
Specifies the priority level of the syslog messages
that are sent. Valid options are:
•debug—information useful for debugging
purposes only
•info—informational messages
•notice—information about conditions that are
not error conditions but nevertheless warrant
special attention
The default value is info.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.