Configuring SNMP 331
/cfg/sys/adm/snmp/users <user ID>
followed by:
authproto md5|sha Specifies the protocol to be used to
authenticate the USM user. Valid options
are:
•md5
•sha
The default is md5.
authpasswd <password> Specifiesthe password for USM user
authentication. The password is required if
the security level is set to auth or priv.
•password is a string that must be at
least eight characters long.
privproto des|aes Specifies the protocol used for encryption.
Valid options are:
•des
•aes
The default is des.
privpasswd <password> Specifiesthe USM user’s individual
encryption key. The password is required
if the security level is set to priv.
•password is a string that must be at
least eight characters long.
del Removes the USM user from the
configuration.

Configuring SNMP notification targets

SNMP managers function as the notification targets for SNMP monitoring.

To configure notification targets, use the following command:

/cfg/sys/adm/snmp/target <target ID>

where

target ID is a positive integer that uniquely

identifies the notification target in the

cluster.

Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.