Configuring the domain 85
Step Action
1Launch the domain quick setup wizard.
>> Main# cfg/quick
2Specify the pVIP of the Nortel SNAS domain.
You can configure additional pVIPs later (see “Configuring
domain parameters” (page 89)).
IP address of domain portal: <IPaddr>
3Specify a name for the Nortel SNAS domain, as a mnemonic aid.
Name of the domain: <name>
4Specify the port on which the portal web server listens for SSL
communications. The default for HTTPS communications is port
443.
Listen port of domain portal [443]:
5Specify the certificate to be used by the portal server.
Use existing certificate (no/1) [no]:
If certificates exist on the system, the certificate numbers will be
offered as valid input options. Choose one of the following:
aTo create a new certificate by pasting in the contents of a
certificate file from a text editor, press Enter to accept the
default value (no). Go to step 6.
bTo create a test certificate, press Enter to accept the default
value (no). Go to step 7.
cTo use an existing certificate, enter the applicable certificate
number. Go to Step 8.
Use the /info/certs command to view the main attributes of
all configured certificates. The certificate number is shown in the
Certificate Menu line (for example, Certificate Menu 1:).
For more information about certificates and keys, see “Managing
certificates” (page 297).
6To create a new certificate:
aAt the prompt to create a test certificate, enter No.
bWhen prompted, paste in the certificate and key from a text
file, then press Enter.
cEnter an ellipsis (...) to signal the end of the certificate.
dTo continue, go to Step 8.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.