392 Configuration example
Figure 31
After all DHCP scopes have been created
--End--
Configure the network core router
There are no special requirements for the core router in a Nortel SNAS
network. Refer to the regular documentation for the type of router used
in your network.
Step Action
1Create the Red, Yellow, Green, VoIP, and Nortel SNAS
management VLANs.
2Assign the VLAN port members.
Since the edge switches in this example are operating in Layer
2 mode, enable 802.1q tagging on the uplink ports to enable
them to participate in multiple VLANs, then add the ports to the
applicable VLANs.
3Create IP interfaces for the VLANs.
4Since the edge switches are operating in Layer 2 mode,
configure DHCP relay agents for the Red, Yellow, Green, and
VoIP VLANs.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.