Initial setup 53
Enter VLAN tag id (or zero for no VLAN) [0]:
7Configure the interface for client portal traffic (Interface 2).
aSpecify a port number for the client portal interface. This port
will be assigned to Interface 2. The port number must not be
the same as the port number for the management interface
(Interface 1).
bSpecify the RIP for Interface 2.
cSpecify the network mask for the RIP on Interface 2.
dIf the core router attaches VLAN tag IDs to incoming packets,
specify the VLAN tag ID used.
Enter port number for the traffic interface [1-4]:
<port>
Enter IP address for this machine (on traffic
interface): <IPaddr>
Enter network mask [255.255.255.0]: <mask>
Enter VLAN tag id (or zero for no VLAN) [0]:
8Specify the MIP of the existing cluster.
The system is initialized by connecting to the
management server on an existing iSD, which must be
operational and initialized.
Enter the Management IP (MIP) address: <IPaddr>
9Specify the default gateway IP address for Interface 2. The
default gateway is the IP address of the interface on the core
router that will be used if no other interface is specified. The
default gateway IP address on Interface 2 must be within the
same subnet as the RIP for Interface 2.
Enter default gateway IP address (on the traffic
interface): <IPaddr>
10 Provide the correct admin user password configured for the
existing cluster.
Enter the existing admin user password: <password>
11 Wait while the setup utility finishes processing. When processing
is complete, you will see Setup successful.
The new Nortel SNAS automatically picks up all other required
configuration data from the existing Nortel SNAS in the cluster.
After a short while, you receive the login prompt.
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.