Nortel Networks , Managing network access devices

58 Managing the network access devices
•Create the domain, if applicable. If you ran the quick setup wizard
during initial setup, Domain 1 is created. For more information about
creating a domain, see “Configuring the domain” (page 79).
•Configure the edge switches for Nortel SNAS (see “Nortel SNAS
configuration roadmap” (page 37), step 4). For detailed information
about configuring the edge switches for Nortel SNAS, see Release
Notes for the Ethernet Routing Switch 8300, Software Release 2.2.8
,orRelease Notes for Nortel Ethernet Routing Switch 5500 Series,
Software Release 5.0.1,.
For secure communication between the Nortel SNAS and the network
access devices, each must have knowledge of the other’s public SSH key.
After you have added the network access devices to the Nortel SNAS
domain, you must exchange the necessary SSH keys (see “Managing
SSH keys” (page 68)).
You require the following information for each network access devices:
•IP address of the switch
•VLAN names and VLAN IDs for the Red, Yellow, and Green VLANs
•the TCP port to be used for Nortel SNAS communication
•for Ethernet Routing Switch 8300 switches, a valid rwa user name
Managing network access devices
The Nortel SNAS starts communicating with the network access devices
as soon as you enable the switch on the Nortel SNAS by using the
/cfg/domain #/switch #/ena command.
You cannot configure the VLAN mappings for a network access devices in
the Nortel SNAS domain if the switch is enabled. When you add a network
access devices to the domain, it is disabled by default. Do not enable the
network access devices until you have completed the configuration. To
reconfigure the VLAN mappings for an existing network access devices,
first disable it by using the /cfg/domain #/switch #/dis command.
Roadmap of domain switch commands
The following roadmap lists the CLI commands to configure the network
access devices in a Nortel SNAS deployment. Use this list as a quick
reference or click on any entry for more information:
Command Parameter
/cfg/domain #/switch <switch ID>
/cfg/domain #/switch #/delete
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.