60 Managing the network access devices

Adding a network access devices

You can add a network access devices to the configuration in two ways.
You must repeat the steps for each switch that you want to add to the
domain configuration.
•“Using the quick switch setup wizard” (page 60)
•“Manually adding a switch” (page 62)

Using the quick switch setup wizard

To add a network access devices to the Nortel SNAS domain using the
quick switch setup wizard, use the following command:
/cfg/doamin #/quick
You can later modify all settings created by the quick switch setup wizard
(see “Configuring the network access devices ” (page 64)).
Step Action
1Launch the quick switch setup wizard.
>> Main# /cfg/domain #/quick
2Specify the IP address of the network access devices.
IP address of Switch: <IPaddr>
3Specify the SNMP profile of the network access devices.
If the quick setup of your domain is not completed in this case
most likely there is no SNMP profile to select. See “Configuring
SNMP Profiles” (page 75) for more information.
SNMP profile:
4It searches for the SNMP settings for the switch.
You will receive an error message and be prompted to use the
sscp or sscplite.
Starting auto discovery........
Using default SNMP Profile for auto discovery.........
.
Error: Auto Discovery Failed !! Please check the SNMP
settings in the Switch
Do you want to use sscp or sscplite <sscp/sscplite>
[sscp]:
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.