180 Configuring authentication
/cfg/doamin #/aaa/auth #/adv
followed by:
servers in cases where the first authentication
method is token based or uses client certificate
authentication.
ATTENTION
Not supported in Nortel Secure Network
Access Switch Software Release 1.6.1.

Configuring RADIUS authentication

To configure the Nortel SNAS domain to use an external RADIUS server
for authentication, use the following command:
/cfg/doamin #/aaa/auth <auth ID>
where auth ID is an integer in the range 1 to 63 that uniquely identifies
the authentication method in the Nortel SNAS domain. If you do not
specify the auth ID in the command, you are prompted for it.
When you first create the method for the domain, you must enter the
authentication ID. After you have created the method and defined a name
for it, you can use either the ID or the name to access the method for
configuration.
You can perform the following configuration tasks:
•“Adding the RADIUS authentication method” (page 181)
•“Modifying RADIUS configuration settings” (page 182)
•“Managing RADIUS authentication servers” (page 184)
•“Configuring session timeout” (page 186)
Nortel Secure Network Access Switch
Using the Command Line Interface
NN47230-100 03.01 Standard
28 July 2008
Copyright © 2007,2008 NortelNetworks
.