Oki 7300e manual Installation of TCP/IP Protocol, Windows Version, Method

Installation of TCP/IP Protocol

There are a number of options available when printing using TCP/IP for Windows. The following table lists the options:

Windows Version	Method
Win 95/98/Me	OKI LPR Utility
NT 4.0	OKI LPR Utility
	Microsoft LPR1
Windows 2000/ Windows XP	OKI LPR Utility
	Microsoft LPR1
	Port 91001
	IPP1

1These functions are built into Windows and are displayed as options when using the Add Printer Wizard.

Although there are some differences in configuration options between the various Windows platforms, the procedure for printing using TCP/IP is the same.

1.Ensure that the TCP/IP protocol has been installed in Windows. This can be confirmed by checking the network settings from within the Control Panel. If TCP/IP has not been installed refer to the section below Installation of TCP/IP protocol.

2.If not already configured, a suitable IP address, Subnet Mask and Gateway address should be configured. Please refer to the on-line help if necessary. It is vital that the IP address entered is unique and valid. Entering an incorrect IP address may cause severe network problems. Please check the address with the network administrator.

3.If your network environment uses domain names, DNS should be enabled and configured on your system. However, this step is not essential to enable network printing.

4.Restart the operating system.

Microsoft Windows 84