Installation (The installation work must be performed by your dealer without fail.)
OMounting a camera
When mounting a camera to the pan/tilt head, take appropriate measures to prevent the camera from falling or being stolen.
1.Place the camera on the camera mounting base and insert the guide pin into the guide hole on the camera.
2.Tighten the 2 camera mounting screws to fix the camera firmly in place.
3.After mounting the camera, check that it is firmly attached and that there is no play.
<Notes>
OBe sure to tighten all screws firmly with a screwdriver or similar tool.
OWhen there is only 1 hole on the camera, remove the 2 camera mounting screws from the camera mounting base, then insert 1 camera mounting screw into the center hole on the camera mounting plate and tighten it to fix the camera in place.
Camera guide pin
Camera mounting Screw
Camera mounting Screw
OAdjusting slack in the chain
The chain length allows for some degree of slack.
Remove any slack after attaching the camera to the pan/tilt head by twisting the chain around as shown in the figure at right, then firmly tighten the screw to fix it in place.
With the AW-E350/AW-E650
With the AW-E655/AW-E750/AW-E860
- 17 -
