Operating preset memory (PMEM) (continued)
Setting the operation items for when preset memory is recalled (PRESET SCOPE)
You can select whether to recall all or only some of the settings registered to preset memory.
Note
zzThis function is enabled when
1.Press one of the camera selection buttons [CAMERA SELECT/GROUP SELECT] to select the remote camera to be operated..
2.Press the PMEM button to turn on its indicator..
3.Press the MEM SETTING button to turn on its indicator..
The setting of the selected remote camera is displayed.
SPEED : 30 
SCOPE : MODE A 
4.Turn the F2 dial to select a setting for the “SCOPE” item from MODE A to MODE C, and then press the F2 dial to confirm the selection..
The setting of the remote camera is changed. This is applied the next time the preset is recalled.
<SCOPE settings and recalled items>
|
| Recalled item |
| |
Setting | Pan, tilt, zoom, |
| White balance | |
Iris | adjustment | |||
| and focus | |||
|
| value | ||
|
|
| ||
MODE A | √ | √ | √ | |
MODE B | √ | √ | — | |
MODE C | √ | — | — |
√: Recalled
Note
zzMODE A to MODE C are not registered to the remote camera preset memory or the unit. The settings become the common settings for when preset memory is recalled, and the same settings are applied regardless of which preset number is selected.
Registering the speed at which to move to the position set in the preset memory
(PRESET SPEED)
The unit registers the speed (PRESET SPEED) at which to move to the set position when preset memory is recalled to each preset number. When a preset is recalled, the unit sets PRESET SPEED on the remote camera and the remote camera moves to the preset position at the speed set for PRESET SPEED.
Performing operation at a different speed for each preset memory enables video to be played at a variety of speeds.
Notes
zzThe movement speed registered in the procedure below is registered to the corresponding camera number, and is not registered to the preset memory of the remote camera. Therefore, if the preset memory is recalled from a controller other than this unit on which the movement speed was registered, movement will be at a different speed even in the case of the same preset number.
zzWhen the connection type or connection destination IP address is changed with CTRL TYPE menu [36], AUTO IP menu [37], or SWAP IP menu [38], PRESET SPEED set for the corresponding camera number is initialized.
1.Press one of the camera selection buttons [CAMERA SELECT/GROUP SELECT] to select the remote camera to be operated..
2.Press the PMEM button to turn on its indicator..
3.Press the MEM STORE button to turn on its indicator..
4.Press the MEM SETTING button to turn on its indicator..
The setting of the selected remote camera is displayed.
SPEED : 30 
SCOPE : MODE A 
5. Turn the F1 dial to select the setting of the “SPEED” item, and then press the F1 dial to confirm the selection..
The following shows the relationship between the set value and the speed at which the remote camera moves to the set position when preset memory is recalled.
1 
30
SlowFast
6.Hold down a number button to specify the preset number to register..
The current remote camera settings are registered to preset memory, and PRESET SPEED is registered to the unit.
15
