Panasonic KX-FPG376, KX-FPG377 manual Direct commands for programming features

8. Programmable Features

To transfer a recorded incoming message to another telephone (page 58), activate this feature and program the transfer telephone number.

1.Press {MENU}.

2.Press {#}, then {6}{0}.

3.Press {A} or {B} repeatedly to select “ON”.

4.Press {SET}.

5.Enter the transfer telephone number.

6.Press {SET}.

7.Press {MENU}.

Code #61: Checking, recording or erasing the transfer greeting message

TRNS-GREETING

CHECK [±]

See page 58 for details.

Code #67: Setting the incoming message monitor

ICM MONITOR

MODE=ON [±]

To hear an incoming message (ICM) from the speaker when the answering machine is recording the message.

“ON” (default): You can monitor the incoming message.

“OFF”: Deactivates this feature.

Code #70: Calling your pager

PAGER CALL

MODE=OFF [±]

See page 59 for details.

Code #76: Setting the connecting tone

CONNECTING TONE

MODE=ON [±]

If you often have trouble when sending faxes, this feature allows you to hear connecting tones; fax tone, ring back tone and busy tone. You can use those tones to confirm the status of the other party’s machine.

LIf the ring back tone continues, the other party’s machine may not be a facsimile or may have run out of paper. Check with the

other party.

LThe connecting tone volume cannot be adjusted.

“ON” (default): You will hear connecting tones.

“OFF”: Deactivates this feature.

Code #77: Changing the receiving mode in the AUTO ANSWER setting

AUTO ANSWER

MODE=TAM/FAX [±]

“TAM/FAX” (default): Telephone Answering Machine/Fax mode (page 45)

“FAX ONLY”: Fax only mode (page 46)

Code #80: Resetting advanced features to their default settings

SET DEFAULT

RESET=NO [±]

To reset the advanced features:

1.Press {MENU}.

2.Press {#}, then {8}{0}.

3.Press {A} or {B} repeatedly to select “YES”.

4.Press {SET}.

5.Press {SET} again.

6.Press {MENU}.

8.4Direct commands for programming features

You can also select the desired setting by directly entering the program code (# and a 2-digit number) and direct command.

For more details on the features, see page 60 to page 64.

1Press {MENU}.

2Press {#} and the 2-digit code number.

3Press the desired direct command, using the dial keypad, to display the desired setting. L This step may be slightly different

depending on the feature.

4Press {SET}.

5To exit programming, press {MENU}.

8.4.1Program code and direct command button

{#}{0}{0} Quick Setup

–{1}: “TAM/FAX” (default)

–{2}: “DIST. RING”

–{3}: “TEL ONLY”

–{4}: “FAX ONLY”

LPress {SET} 2 times before pressing the direct command button.

64