Panasonic KX-TG2970 operating instructions General, Charge for 6 HRS

						Troubleshooting
General
		Problem				Cause & Remedy
	The unit does not work.					• Check the settings (p. 10–13).
						• Check whether the dialing mode setting is
						correct (p. 19).
						• Fully charge the battery (p. 12).
						• Clean the charge contacts and charge again
						(p. 13).
						• Check battery installation (p. 11).
						• Unplug the base unit’s AC adaptor to reset it.
						Plug in, and try again.
						• The cordless handset has not been
						registered to the base unit. Register the
						cordless handset (p. 27, 69).
						• Re-install the battery (p. 11) and fully charge
						it.
						• Verify the correct AC adaptor is connected to
						the base unit.
	“Recharge battery” is					• Fully charge the battery (p. 12).
	displayed, “		” flashes or
	the cordless handset beeps
	intermittently.
	“Charge for 6 HRS” and					• The battery has been discharged. Fully
	“	” are displayed and the				charge the battery (p. 12).
	cordless handset does not
	work.
	You charged the battery fully,					• Clean the charge contacts and charge again
	but “Recharge battery” is					(p. 13).
	still displayed and/or “				”	• The battery may need to be replaced. If you
	continues to flash, or “Charge					install a new battery, fully charge it (p. 11, 13).
	for 6 HRS” and “			” are
	displayed.
	The CHARGE indicator does					• This is normal.
	not go out after the battery has
	been charged.
	If you cannot solve your					• Read the Operating Instructions or
	problem					Quick Set-Up Guide.
						• Please call 1-800-ADT-ASAP

Useful Information

For assistance, please call: 1-800-ADT-ASAP

77