Panasonic PT-D7600U operating instructions When the operation mode selector is set to Computer

ON POWER OFF

		AUTO
		SETUP
RGB	RGB	AUX
1	2
		SHUTTER
VIDEO	S-VIDEO	SHUT

MENU FREEZE

PAGE UP

ENTER

PAGE DOWN

ON SCREEN

1 STD 2 OSD 3 SYSTEMSEL

		D.ZOOM
4	FUNC	5	6
	1
		BRIGHT	CONTRAST
7 LENS		8	9
	NEXT	ASPECT	0 USER
	LIGHT	ID ALL	ID SET
Computer			LASER ON/OFF
			Projector
	Numetric

				SHUT
		X	HUTTER
PU			UA	S
OT	TE	S			2
	UA			B
					GR
		F
		FO
			R	EW
				OP	NO

ro

T

FFO/

tc

je

NO

RE

ES

ID

roP

USER

SAL

LA

L

trice

TN

ID

0

HComputer

AR

ASPECT

T

N

TS

9

OC

T

IGL

M

YS

6

RIGHTB

8

XE

N

ETSEL

SN

ZOOM.

3

DS

D

5

EL

7

NEER

CS

O

CNU1

NW

NO

2

D

F

4

R

O

D E

G

TS

ENTE

1

AP

PU

EG

AP

EZ

EE

OE

RF

DIV

PAGEMENU

-S

VIDEOPAGE

B

1

GR

USER button

Displays the sub-memory screen of the signal registration.

LIGHT button ( Click button)

When this button is pressed, the remote control button light is turned on.The light goes off about 30 seconds after you stop remote control operation.

ID ALL button (page 16,70)

When two or more main units are used in the system, this button switches to the mode to control them simultaneously with a single remote control.

ID SET button (page 16,70)

When two or more main units are used in the system, this button specifies the ID of the remote control.

Remote control wired terminal (page 17) To use the wired output terminal, connect the remote control and the main unit with the supplied cable.

Remote control transmitter window

Operate the remote control aiming at the remote control receiver window on the main unit.

<When the operation mode selector is set to Computer>

ENTER button

Moves the mouse cursor.

( ) buttons

These buttons correspond to the left and right mouse buttons.

PAGE UP/PAGE DOWN buttons

These buttons correspond to the PAGE UP/PAGE DOWN buttons on PC's keyboard.

Numeric (0-9) button

In a system that uses two or more units of this projector or in a system that connects to an optional signal selector, these buttons specify a particular projector unit or the input of the signal selector. They are also used to enter ID numbers when selecting the ID or to enter specific numbers when entering a password.

Operation mode selector (Computer/Numeric, Projector) switch (page 17)

Put this selector to the right position to control the projector and to the left position to control the PC or use numeric buttons.

Click button (page 17)

This button corresponds to the left mouse button when the operation mode is switched to the Computer position.

Note • To use the remote control as a mouse, please purchase an optional wireless mouse receiver (model No.: ET-RMRC1).

•The AUX button to switch the input is disabled when an optional input module is not connected.

11