Panasonic PT-D7600U To input Betacam with YCbCr, To set the sRGB compliant picture, Signal level

Adjusting the picture

To set the sRGB compliant picture

sRGB is the international color reproduction standard (IEC61966-2-1) established by IEC (International Electrotechnical Commission).

Perform the following setting procedure to reproduce the higher-fidelity picture in compliance with sRGB.

1.Set color matching adjustment to “OFF”.

2.Press the buttons on the “PICTURE” menu and select the “PICTURE MODE”.

Set to “NATURAL” with the buttons.

3.Select the “COLOR” with the buttons.

Press the STD (standard) button on the remote control to restore the factory default. Follow the same procedure to restore the factory default for “TINT”, “COLOR TEMP.” and “GAMMA”.

Note • sRGB is only enable when RGB signals are being input.

To input BETACAM with YCbCr 480i

When receiving a picture of 480i with analog component signal YCbCr input, the input level of Cb and Cr can be switched.

MAIN MENU

PICTURE

POSITION

LANGUAGE

OPTION

TEST PATTERN

SIGNAL LIST

:MENU SELECT

ENTER:SUB MENU

PICTURE

FORMAT	SMPTE
PULLDOWN MODE	AUTO
COLOR MATCHING	USER

:MENU SELECT :CHANGE

Press the “MENU” button.

The MAIN MENU screen will be displayed.

Select “PICTURE” with the buttons.

Press “ENTER” button.

The PICTURE screen will be displayed.

Select “FORMAT” with the buttons.

Switch the signal format with the buttons.

•This toggles between SMPTE and BETACAM.

<Signal level>

Format	Y	Synchronous part	Cb , Cr
SMPTE	700 mV	300 mV	±350 mV
BETACAM	714 mV	286 mV	±504 mV

Note • This function is available only when input signals are supplied through the analog RGB input module (ET-MD95RGB). RGB1, RGB2 inputs do not support BETACAM signals.

•This function can be switched only when receiving the picture of 480i in the YCbCr mode.

It cannot be switched when receiving the picture of signals other than RGB-REALITY mode, RGB mode and 480i.

•SMPTE is the factory default.

56