Option settings
ID number setting
The projector has an ID number setting function that helps the user to control two or more projectors either simultaneously or separately with a single remote control. The ID number is set to "ALL" by default. Hence the
ID number need not be set when only one projector is used.
Procedure of setting
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT
ENTER:SUB MENU
OPTION
ID | 2 |
SETTING | |
LAMP1 RUNTIME | 57h |
LAMP2 RUNTIME | 60h |
LAMP SELECT | DUAL |
LAMP POWER | HIGH |
LAMP COOLING TIME | SHORT |
RS232C SETTING |
|
RGB2 SELECT | RGB1 OUT |
OSD POSITION | 1 |
:MENU SELECT |
|
:CHANGE |
|
Press the “MENU” button.
The MAIN MENU screen will be displayed.
Select “OPTION” with the buttons.
Press the “ENTER” button.
The OPTION screen will be displayed.
Select “ID” with 
buttons and
change the value with 
buttons (ALL, 1, 2, …64).
Press the “MENU” button twice.
This concludes the setting procedure and the on- screen indications disappear and the normal screen appears again.
Note • The ID number can be set to “ALL”, or selected from “1” to “64”.
•If the projectors are given ID numbers, their remote controls must be assigned the same ID numbers, respectively.
•If the ID number of a projector is set to “ALL”, it can be controlled by the remote control or the PC with any ID number.
If multiple projectors are used and some of them have their IDs set to “ALL”, they cannot be controlled separately from the projectors with other ID numbers.
For details on remote control ID setting, see page 16.
70
