Panasonic PT-D7600U Indication of monitor lamp, Lamp Information Checkpoint Remedial measure

Indication of monitor lamp

Three monitor lamps are provided at the top of main unit front to inform the user of the lamp replacement time and unusual internal temperature. These lamps indicate the degree of abnormality by combination of blinking and/or lighting lamps. Turn off the power and take the proper measure according to the table below.

TEMP LAMP1 LAMP2 POWER

					Lamp 2 monitor (LAMP2)
					Lamp 1 monitor (LAMP1)
					Temperature monitor (TEMP)
Name of monitor	Lamp	Information		Checkpoint		Remedial measure
lamp	indication
	Lighting in					• Remove the object that is
						blocking the ventilation port.
	red	High temperature	• Check if the
						• Move the projector to a
	(lamp unit	inside.	ventilation port is
						temperature of 0 to 40 ˚C and
Temperature	ON)		blocked.
						the humidity of 20 to 80% (no
			• Is the room air
monitor						condensation).
			temperature too high?
	Blinking in	High temperature				• Turn off the MAIN POWER
TEMP	red	inside	• Check the air filter for			switch using the procedure on
			clogging.
	(2 times)	(Standby condition)				page 40 and clean the air filter
						(refer to page 95).
	Blinking in					• Turn off the main power supply
		Cooling fan has				(MAIN POWER) switch in the
	red
		been stopped.				procedure shown on page 40
	(3 times)
						and consult the distributor.
			• Did you notice a
			“REPLACE THE			• This lamp monitor lights up
	Lighting in	Indicates the time	LAMP” message on			when the lamp unit used hours
		for replacing the	the screen when			have reached 1 300 hours.
Lamp monitor	red
		lamp unit.	turning on the			Request the dealer to replace
LAMP1 LAMP2			projector power			the lamp unit.
			supply.
			• Some error has
	Blinking in		arisen in the lamp			• Turn off the MAIN POWER
		Error is detected in	circuit.			switch using the procedure on
	red
		the lamp circuit.	• Check for fluctuation			page 40 and consult the
	(3 times)
			(or drop) in the source			dealer.
			voltage.

Attention • Be sure to observe the procedure (How to turn “ON” and “OFF” the power supply) on page 39–40 when performing power supply operation to take a measure to the indication of temperature

monitor (TEMP) lamp and lamp monitor (LAMP) lamp.

94