Paradyne 8546, 8540 manual Snmp Traps

SNMP Traps

Table B-1. DSL Card Traps (2 of 4)

Event

Severity

Comment

Trap # MIB

Device failure	major	Access Node’s operating	15	hot_sys.mib
		software has detected an		(Hotwire
		internal device failure.		system)
DHCP filter	minor	Cannot add new route to	11	hot_dhcp.mib
security failure		route table because		(Hotwire DHCP
		maximum number of stored		Relay Agent)
		rules reached.
xDSL link down	major	Sending protocol entity	21	hot_xdsl.mib
analysis trap		recognizes that the xDSL		(Hotwire XDSL
		communication link is down		Interface)
		and lists reason:
		H Normal – Normal
		power-up training
		sequence
		H Rate adaption – Retrain
		due to rate adaption
		speed change
		H Low margin – Retrain
		due to margin falling
		below threshold
		H Low RSL – Retrain due
		to receive signal level too
		low
		H High SNL – Retrain due
		to signal-to-noise level
		too high
		H High CRCs – Retrain due
		to excessive cyclic
		redundancy check errors
		H High RS – Retrain due to
		excessive Reed-Solomon
		buffer overflows
		H Change power – Retrain
		due to startup message
		containing a different
		transmitter power level
		than the current
		operating level
		H Default power – Retrain
		and revert to default -6bl
		transmitter level after a
		failure to train at the last
		configured level
xDSL link up or	minor	Number of link down events	1	hot_xdsl.mib
down		above threshold. This rate is		(Hotwire XDSL
Transitions		limited to once every		Interface)
		15 minutes.
threshold
exceeded

B-4 April 2000 8000-A2-GB20-50