Paradyne 8546, 8540 manual Radsl Cards, Use this MCC Card This Hotwire Chassis

Hotwire DSL System Description

MCC Card

The DSLAM and GranDSLAM chassis require one MCC card, which is a processor card that administers and provides management connectivity to the DSL cards. It acts as a mid-level manager and works in conjunction with a Simple Network Management Protocol (SNMP) system, such as Paradyne’s OpenLanet DCE Manager for HP OpenView, via its LAN port. It gathers operational status for each of the DSL cards and responds to the SNMP requests. It also has a serial port for a local user interface to the chassis. The following MCC cards are used in the Hotwire chassis:

Use this MCC Card . . .

In this Hotwire Chassis. . .

MCC, MCC Plus

8600, 8800, or 8810 DSLAM

MCP

8610 DSLAM or 8820 GranDSLAM

For more information, see the Hotwire Management Communications Controller (MCC) Card User’s Guide.

NOTE:

All references to MCC cards in this document refer to the MCC, MCC Plus and MCP cards, unless specifically noted otherwise.

RADSL Cards

In addition to an MCC card, the chassis requires at least one DSL card, such as an 8540 or 8546 RADSL card. These circuit cards contain RADSL ports, an Ethernet interface to the Internet Service Provider (ISP), and a processor/packet forwarder. The processor/packet forwarder controls the endpoints and forwards the packet traffic via the Ethernet and RADSL interfaces.

When this card . . .	Fully populates this	Total number of DSL
	Hotwire chassis . . .	ports supported is . . .
8540 or 8546 (4 ports)	8600/8610 with 5 expansion	68
	chassis
	8800/8810	72
8546 (4 ports)	8820	68

H8540/8546 RADSL Cards – Contains four ports. RADSL cards are targeted primarily for commercial environments and offer high-speed, rate-adaptive services over copper wire. Applications such as Internet access, video teleconferencing and LAN extension are supported.

1-6 April 2000 8000-A2-GB20-50