Paradyne 8546, 8540 manual Configuring the MCC Card, DSL Cards, and RTUs

RADSL Card Configuration

Configuring the MCC Card, DSL Cards, and RTUs

Use the procedures in the following order to configure the MCC card and RADSL cards for the basic setup for terminal management and user data connectivity.

NOTE:

It is assumed that you have read the Hotwire 8540 and 8546 RADSL Cards Network Configuration Guide and have assigned service and management domain IP addresses for all devices (MCC, DSL, and RTUs).

The following tables list the basic steps you need to do to configure the MCC cards, DSL cards, and RTUs.

For the Management Domain, perform task . . .

On the . . . See the . . .

1.	Configure time and date.	MCC	Hotwire Management
			Communications Controller (MCC)
2.	Assign the IP address to the	MCC
			Card User’s Guide
	backplane on the MCC card.
3.	Assign the IP addresses to the	MCC
	DSL cards.
4.	Create SNMP Community Strings	MCC
	and Authentication Failure Trap.
5.	Create default route.	MCC
6.	Reset the MCC card.	MCC
7.	Select a DSL card to configure.	DSL	Card Selection Screen in Chapter 2,
			Hotwire Menus and Screens.
8.	Configure 5446 RTU IP host	DSL	DSL Card Configuration Interfaces
	address for the 8546 RADSL		Screens, page 3-15(A-C-B).
	card. (Not applicable to 8540
	RADSL card.)

For each Service Domain,		On the . . .	See . . .
perform task . . .
1.	Configure a static route to the	DSL	DSL Configuration IP Router
	NMS.		Screens, page 3-20(A-E-A).
2.	Assign IP addresses to the DSL	DSL	DSL Card Configuration Interfaces
	card LAN.		Screens, page 3-15(A-C-B).
3.	Reset the DSL card.	DSL	DSL Configuration Card Status
			Screens, page 3-7(A-A-F).
4.	Create DHCP Relay Agent.	DSL	Configuring DHCP Relay Agent
			(dynamic addressing),
			page 3-29(A-G).
5.	Create default route or source	DSL	DSL Configuration IP Router
	route on DSL.		Screens, page 3-20(A-E-A).
6.	Create SNMP Community Strings	DSL	DSL Configuration SNMP Screens,
	and Authentication Failure Trap.		page 3-26(A-F-B).
7.	Configure RTU Information	DSL	DSL Configuration RTU Screens,
			page 3-31(A-H-A).

3-2 April 2000 8000-A2-GB20-50