1. Installation
6.Install two wood screws (not provided) at the same height above the floor and 18.75 inches (476.25 mm) apart. Do not completely tighten the screws. Leave them so their heads are about 1/4 inch (6 mm) from the wall.
18.75 in (476.25 mm) |
7.Hang the unit from the wood screws to verify that the screws are properly placed. The screws should freely slide into the top of the key slots in the brackets.
8.Do not fasten the unit to the wall until after it is completely cabled and tested. Proceed to Installing the Uplink Module on page
October 2002 |
