Paradyne GranDSLAM 4200 manual Console Port

2. Cabling

Console Port

The CONSOLE port normally serves as the primary user interface with the GranDSLAM 4200 during installation. You can connect a terminal or PC directly to the CONSOLE port using a DTE cable (see procedure below). You can also use the CONSOLE port to attach a modem to the GranDSLAM 4200 for remote dial-in management of the unit using a DCE cable (see procedure on next page).

Procedure

To connect a terminal or PC to the CONSOLE port:

1.Configure the terminal or terminal emulation program to use the following parameters:

—Maximum speed: 9600 bps

—Data bits: 8

—Parity: None

—Flow Control: None

—Stop bits: 1

2.Determine and procure the proper Data Terminal Equipment (DTE) cable type. The CONSOLE port requires a DB9 plug connector. The other connector depends on the serial port on your terminal or PC.

3.Connect the DB9 plug connector to the CONSOLE port socket. The CONSOLE port is ordinarily used only during installation, so do not fasten the connector.

4.Connect the other end of the cable to the serial port of your terminal or PC.

Serial

RTN	-
	48VDC

B3.5 A 60

A

ALARM

Port

CONSOLE

Port

POWER A B

BITS MGMT

SUT KNI ATS LPU
MRL TSE A T	4202		TX
	E1	MODULE	75W	RX
				100/120W	1	4
							8
								12

13	16	20
			24

DSL PORTS 1-24

02-17271

2-10 October 2002 4200-A2-GN20-10