Paradyne GranDSLAM 4200 manual DSL Ports

2. Cabling

DSL Ports

The GranDSLAM 4200 DSL connector supports the tip and ring connections of up to 24 DSL ports over a 50-position cable. A POTS (plain old telephone service) splitter connector is also provided. If your model does not contain the integrated POTS splitter, you must connect the unit to a separate POTS splitter.

Procedure

To cable the DSL Ports:

1.Insert a cable tie (provided) through the top of the anchor mount next to the DSL PORTS 1–24 connector.

2.If the connector for your cable has a short captive screw, attach the cable to the DSL PORTS 1–24 connector and fasten it to the jack screw with its short captive screw.

#4-40	Anchor
Jack Screw	Mount

Short

Screw

50-Pin

Connector02-17083

3.If the connector for your cable has a long captive screw, remove the provided jack screw from the threaded hole next to the DSL PORTS 1–24 connector. Attach the DSL PORTS 1–24 connector to the unit using the long, captive pan-head screw (provided).

Anchor

Mount

Long

Screw

50-Pin02-17346

Connector

4. Tighten the cable tie around the connector and trim the excess.

02-17084

5.If using an integrated POTS splitter, the POTS 1–24 connector is used. Repeat Step 1 through Step 4, substituting POTS 1–24 for DSL PORTS 1–24.

6.Secure the cables as required for strain relief.

2-2 October 2002 4200-A2-GN20-10