Paradyne manual GranDSLAM 4200 Turn-up Procedure, Rtrv ?

4. Configuration

TCommand query. You can obtain help with CLI commands by typing a ? (question mark). A question mark alone lists all commands.

For example, if you enter:

RTRV ?

the CLI lists all the possible RTRV commands.

Command history. Pressing the Up Arrow key while entering a command returns the CLI to the previous command entry.

RTRV-META command. Retrieves all commands.

GranDSLAM 4200 Turn-up Procedure

You can turn up your GranDSLAM 4200 through the Ethernet connection via a PC or terminal connected to the unit’s CONSOLE port. Then, using a series of TL1 commands or an NMS system such as Paradyne’s GrandVIEW Element Management System (EMS), you configure the unit for operation.

he turn-up procedure for the GranDSLAM 4200 system differs, depending on the type of management used:

Inband Management – Operates over the ATM interface. This is the default for the GranDSLAM 4200.

Out-of-Band Management – Operates over the Ethernet interface.

he turn-up procedure for both management types also differs, depending on whether you are in Manual mode (no DHCP server), or in DHCP (BOOTP) mode using a DHCP server.

Manual Mode – If a DHCP server is not being used, you must manually assign

Tan IP address to your GranDSLAM 4200.

DHCP Mode – If you are using a DHCP server, you do not need manually assign an IP address since this is done automatically.

4200-A2-GN20-10 October 2002 4-3