2. Cabling
Procedure
To connect the ALARM interface:
1.Strip the tips of the alarm source wires (about 1/2 inch or 12.7 mm in length).
2.For Model 4210, insert the wires into the
For Models 4220/4230, use a screwdriver to press the orange spring tab in while inserting the wire into the hole below it.
NOTE:
For all models, the insulation should be fully within the plug and no bare wire should be exposed outside of the plug.
Spring
Tab
|
3.Insert the plug into the ALARM interface on the front panel of the GranDSLAM 4200.
4.If the GranDSLAM 4200 is in a rack, dress the cable to the left and secure it to the rail with a cable tie.
October 2002 |
