Controls

7.09

Controlpanel (only on machines with Quick-flange motor)

24

1

3

SPEED TE ERROR

3 3 3 3

A B C D

The control panel consists of display1 and the function keys described below. The display1 consists of a single-line alpha-numerical, 7 segment LCD display with 8 symbols. The texts 2, located above and next to the LCD display, show the respective status of the function keys and the operating status of the machine. The control panels switches on all LCD- segments and the horn automatically for a short time during the power-on phase, after which the lettering PFAFF appears on the display, until the higher-ranking control unit sends commands to the control panel.

The function keys are located around the display1. They are foil-packed without permanent marking and without contact signal. Fixed functions are allocated to the keys, seeChapter 7.09.02Functionkeys.

7.09.01 Screen displays

Activated functions are displayed with a triangular marking3 below or next to the respective function key.

In the sewing mode all relevant sewing data is displayed and can be changed directly, depending on the status of the machine, see alsoChapter10Sewing.

During the parameter input the selected parameter number with the corresponding value is displayed, seeChapter12.08.02Exampleofaparameterinput.

7.09.02 Function keys

The function keys described below are used basically to switch machine functions on and off.

Each time a key is pressed, this must be confirmed by at least one beep tone. Irrespective of the machine mode a double beep signal is given if invalid keys are pressed or maximum values reached.

If a corresponding value has to be set for the activated function, this is carried out with the corresponding+/-key. By pressing and holding the corresponding+/-key,the relevant numerical value4 is changed slowly to begin with. If the corresponding+/-keyis held down longer, the values change more quickly.

7 - 5