Sensaphone® Model 1108 User’s Manual

To enter “555,” press the number (5) key on the Touch-Tone phone keypad three times. The Model 1108 will respond: *

“Warning message received by telephone number (last number dialed).” The Model 1108 will hang up and the dial- out sequence, including any further response to the alarm, will be cancelled.

If you enter the wrong code or do not enter it within 10 seconds following the conclusion of the message, the Model 1108 will respond: “Dial telephone number (the programmed unit phone number) within (Intercall Time).” Then, the Model 1108 will hang up. The alarm is still not acknowledged until you call back. You have a period equal to the programmed Intercall Time to call the unit back and enter the “555” acknowledgment code. If you are calling from a pulse or rotary telephone, refer to Callback Acknowledgment, Section 6.1.3, below.

6.1.3Callback Acknowledgment

Callback Acknowledgement is a feature that allows you to acknowledge an alarm without entering Touch-Tones. This feature is disabled by default and must be enabled by entering the key sequence below. When Callback Acknowledgment is enabled, simply call the unit back and allow the line to ring 10 times. The unit will then answer the call, give a Status Report, then say “Warning message received by telephone number ...” and recite the telephone number last dialed. This indicates that the alarm has been acknowledged.

To enable or disable Callback Acknowledgement:

1.Press SENSOR ON/OFF.

2.Press PHONE NUMBER.

The model 1108 will say “On” to indicate that Callback Acknowledgment is Enabled, or “Off” to indicate that Callback Acknowledgement is Disabled. This method of remote alarm acknowledgment works with any telephone: pulse, rotary, or Touch-Tone.

86

Page 86
Image 86
Phonetics 1108 user manual Callback Acknowledgment