Parameter | Description |
Destination | A destination network, subnet or host. |
Network |
|
Destination Mask | The subnet mask that specifies the bits to match. A routing entry will be used for a |
| packet if the bits in the address set by the destination mask match the Destination |
| Network. |
VLAN | The VLAN within which the gateway or destination address resides. |
Next Hop | The IP address of the router at the next hop. |
Type | The IP route type for the destination network. This switch supports the following types: |
| Direct - A directly connected subnetwork. |
| Indirect - A remote IP subnetwork or host address. |
| Myself - A switch IP address on a specific IP subnetwork. |
| Bcast - A subnetwork broadcast address. |
| Mcast - An IP multicast address. |
| Invalid - An illegal IP address to be filtered. |
Protocol | The route was learned in one of the following ways: |
| Local - Manually configured |
| Mgmt - Set via SNMP |
| ICMP - Obtained via ICMP redirect. |
| RIP - Learned via RIP protocol. |
| OSPF – Learned via OSPF protocol. |
| Other - Learned by some other method. |
|
|
NOTE: Use the <Next Page> and <Prev Page> buttons to scroll through the routing table. To display a specific page, set the page number in the Page field and then press <Apply>. Select <Flush RIP> to clear any routing entries learned through RIP.
WGS3 Layer 3 Switch User’s Manual | - 114 - |