5.7.6 Configuring Security Filters

You can use the Security menu to filter MAC and IP addresses.

Parameter

Description

MAC Filtering

Specifies the source or destination MAC address for any traffic to be filtered from the

Configuration

switch.

IP Filtering

Specifies the source or destination IP address for any traffic to be filtered from the

Configuration*

switch.

 

 

* This menu item is only displayed for WGS3-404 or multilayer mode of WGS3-2620.

5.7.6.1 Configuring MAC Address Filters

Any node that presents a security risk or is functioning improperly can be filtered from this switch. You can drop all the traffic from a host device based on a specified MAC address. Traffic with either a source or destination address listed in the Security Filtering Configuration table will be filtered.

5.7.6.2 Configuring IP Address Filters

If any node presents a security risk, you can filter all traffic for this node by entering its address into the IP Security Filter. Any packet passing through the switch that has a source or destination IP address matching an entry in this table will be filtered.

WGS3 Layer 3 Switch User’s Manual

- 199 -