5.7.5.1Subnet Configuration). Static routes take precedence over dynamically learned routes and remain in the table until you remove them or the corresponding IP interface from this switch.
Parameter | Description |
Destination | A destination network, subnet or host. |
Network |
|
Destination | The subnet mask that specifies the bits to match. A routing entry will be used for a packet |
Mask | if the bits in the address set by the destination mask match the Destination Network |
VLAN | The VLAN within which the gateway or destination address resides. |
Next Hop | The IP address of the router at the next hop. |
| Note that the network portion of the next hop must match that used for one of the subnet |
| IP interfaces configured on this switch. (See “ |
| 5.7.5.1 Subnet Configuration”.) |
Type | The IP route type for the destination network. This switch supports the following types: |
| Direct - A directly connected subnetwork. |
| Indirect - A remote IP subnetwork or host address. |
Routing | A relative measure of the path cost from this switch to the destination network. |
Metric* |
|
|
|
* This value depends on the specific routing protocol.
WGS3 Layer 3 Switch User’s Manual | - 197 - |