5.7.5 Configuring IP Settings

If this switch is WGS3-404 or WGS3-2620 in multilayer mode, the IP Menu will be displayed.

Use this menu to configure the IP subnets for each VLAN on your switch, the unicast and multicast routing protocols, static ARP entries, static IP routes, and the default IP route.

Parameter

Description

 

 

 

Subnet

IP Subnet Configuration – Specifies the IP interface for VLANs configured on this

Configuration

switch, including the subnet address and routing protocols.

 

Port Group Configuration – See “5.7.3.2 VLAN Table Configuration”.

Protocol

Configures ARP timeout, enables Proxy ARP, sets the preferred servers for

Configuration

BOOTP/DHCP Relay, as well as enabling/configuring unicast and multicast protocols

 

globally for this switch.

Static ARP

Used to map an IP address to a specific physical MAC address.

Configuration

 

Static Route

Used to configure static routes to other IP networks, subnetworks, or hosts.

Default Route

Defines the router to which this switch will forward all traffic for unknown networks.

 

 

WGS3 Layer 3 Switch User’s Manual

- 176 -