LED | Color | Function |
1000 | Green | Lights to indicate that receiver of fibre port is in normal optical input |
|
| levels. |
Act | Green | Lights to indicate that the connection is acting. |
FDX/COL | Yellow | Lights to indicate that the port is operating at full duplex. This port does |
|
| not support half duplex. |
2.3 Mounting the Switch
The switch can be placed directly on your desktop, or mounted in a rack. Before you start installing the switch, make sure you can provide the right operating environment, including power requirements, sufficient physical space, and proximity to other network devices that are to be connected. Verify the following installation requirements:
•Power requirements: 100 to 240 V AC
•The switch should be located in a cool dry place, with at least 10 cm. (4 in.) of space on the sides for ventilation.
•Place the switch out of direct sunlight, and away from heat sources or areas with a high amount of electromagnetic interference.
•If you intend to mount the switch in a rack, make sure you have all the necessary mounting screws, brackets, bolts and nuts, and the right tools.
•Check if network cables and connectors needed for installation are available.
2.3.1 Mounting Switches in a Rack
Please comply with the following instructions to ensure that your switch is securely mounted in the rack.
•Use a standard EIA
•Use the brackets and screws supplied in the rack mounting kit.
•Use a
•Position the switch in the rack by lining up the holes in the brackets with the appropriate holes on the rack, and then use the supplied screws to mount the switch in the rack.
2.4Connecting the Switch System
The transmission speed for each port on the switch is automatically set by the switch to match the highest speed supported by the connected device. The transmission mode can be set for each port using
WGS3 Layer 3 Switch User’s Manual | - 8 - |