MD5 Key Table | When use MD5 authentication mode, you have to specify an active |
| MD5 key on this table. Up to 8 key can be added on the table but |
| only one can be Active. The others should be left to be Valid. To |
| remove the key, set the status to be Invalid and select <Apply>. Each |
| key consists of two parameters: |
| Key ID : An identifier from 1 to 255. |
| Key : An alphanumeric password of up to 16 bytes. |
|
|
1:The Area ID is used to specify a group of contiguous networks and hosts. OSPF protocol broadcast messages are restricted by area to limit their impact on network performance.
2:This value must be the same for all routers attached to a common network.
WGS3 Layer 3 Switch User’s Manual | - 182 - |