Planet Technology WGS3-2620, WGS3-404 2.2.4 Module Hardware Description, Port, NOTE:, Function, Buzzer button, 2.2.4.1 Panel Description, 2.2.4.2 WGSW-C1GTLED Definition

Console Buzzer Button Power

Port	Function
Power	This is where you will connect the AC power cord. 100~240VAC is allowed.
Console	This is where you will connect to the RS-232 serial port on your PC for
	configuring the management function, discussed in Chapter 3.

NOTE: To depress the Buzzer button will change the reaction of the buzzer. If the button is set to on, the buzzer will ring as the system is under the status of overheat. Set to off, the buzzer will not work even if the system overheats.

2.2.4 Module Hardware Description

WGS3-404 provides 4 slots for optional Gigabit copper and fiber module. The following picture show that front panel of gigabit expansion module.

2.2.4.1 Panel Description

WGSW-C1GT Module Status LEDs WGSW-C1SX Module Status LEDs

2.2.4.2 WGSW-C1GT LED Definition

LED	Color	Function
1000	Green	Lights to indicate that the Switch is sending or receiving data at 1000
		Mbps.
100	Green	Lights to indicate that the Switch is sending or receiving data at 100
		Mbps.
10	Yellow	Lights to indicate that the Switch is sending or receiving data at 10
		Mbps.
FDX/COL	Yellow	Lights green to indicate that the port is operating in full-duplex mode.
		Blinks orange periodically to indicate that the connection is experiencing
		collisions.
Act	Green	Lights to indicate that the connection is acting.

WGS3 Layer 3 Switch User’s Manual - 7 -