Auto UDP Broadcast@Reset, as hex state | Pressure Systems 98RK-1

Pressure Systems, Inc.98RK-1 & 9816 User’s Manual©

06	IP Address Resolution Method, as hex state:				13
		0000 = Use Static IP Address stored in module’s non-volatile memory
		0001 = Get Dynamic IP Address from external RARP/BOOTP server
07	TCP Back-Off Delay, as hex value (or FFFF). FFFF means use low-order				14
	byte of module’s Ethernet Address as value instead. In either case, back-off
	delay in microseconds is calculated from decimal equivalent of hex value:
	delay = decvalue * 20
08	TCP/IP Data Field Size Prefix (with 2-byte big-endian binary value),				16
	as hex state: 0000 = None (default)
		0001 = Yes
09	TCP Connect Port, as hex value (e.g. 2328 = 9000 decimal, default).				17
0A	Auto UDP Broadcast@Reset, as hex state:				18
		0000 = No (default)
		0001 = Yes
0B	Position of 4-state Internal Calibration Valves (C1/C2, C3/C4), as hex state:				12/0C
		0000 = RUN position		(C2/C4 Energized, C1/C3 Not)	00/00
		0001 = CAL/RE-ZERO position		(C1/C4 Energized, C2/C3 Not)	00/01
		0010 = LEAK/CHARGE position		(C2/C3 Energized, C1/C4 Not)	01/00
		0011 = PURGE position		(C1/C3 Energized, C2/C4 Not)	01/01
	(see end-of-table NOTE +)		(see also Chart at end of 'w' command)
0C	Temperature Status of Each Scanner Transducer, as 16-bit hex bit map,
	each bit representing the current status of a transducer/channel (16-1)). Bit
	values are:
		0= transducer operating within the specified operational limits.
		1= transducer operating outside the specified limits.
	(see end-of-table NOTE +)
0D	Minimum Temperature Alarm Set Point (in degrees C), as decimal (**)				19
	format 0 representation of internal IEEE float, with leading space).
0E	Maximum Temperature Alarm Set Point (in degrees C), as decimal (**)				19
	format 0 representation of internal IEEE float, with leading space).
0F	Cluster (C), Rack (R), and Slot (S) Address, each item encoded as a hex
	digit (most significant digit always zero): 0CRS
	(see end-of-table NOTE ++)
10	External DH Scan Interval (in seconds) as decimal (**) integer value.				1A
11	Thermal Update Scan Interval (in seconds) as decimal (**) integer value.				1B
(+)NOTE:		These 4-byte hex status fields may also be returned in autonomous data
		streams, but as pure binary extensions of each stream packet’s binary
		header (see ‘c’ command, ii=05, bbbb=0002).

(++)NOTE: The 98RK-1 Scanner Interface Rack can operate as a single unit with up to eight Model 9816 pressure scanners installed in slots of each rack. Racks may also be grouped together in clusters of racks as part of a larger data acquisition system installation. In order to physically identify individual

Page 81

Pressure Systems 98RK-1 user manual IP Address Resolution Method, as hex state, +Note

Models: 98RK-1

IP Address Resolution Method, as hex state:

Auto UDP Broadcast@Reset, as hex state:

(+)NOTE: