Chapter 3 
The Remote Control
Display window
| DIRECTV | ON•OFF | TV | |
| VCR |
|
| DVD |
| 1 |
|
|
|
| VCR |
|
| AUX |
| 2 | AUD |
| |
|
|
| ||
| M1 |
|
| M3 |
Component |
| M2 |
|
|
L1 |
|
| L3 | |
buttons and |
| L2 |
| FRONT |
ON•OFF button | MUTE |
|
| SKIP |
| CH + |
|
| |
| VOL - |
|
| VOL + |
| REAR | CH - |
| CENTER |
| FORMAT |
|
| GO |
|
|
| BACK | |
|
|
|
| |
| TEST |
|
| AM•FM |
| GUIDE |
|
| INFO |
The OK | LEVEL - | OK |
| LEVEL + |
button | MENU |
|
| CLEAR |
| PROGRAM |
|
|
|
| 1 | 2 |
| 3 |
| 4 | 5 |
| 6 |
The down | 7 | 8 |
| 9 |
arrow button | INPUT | 0 |
| ANT |
|
| |||
|
|
|
| FUNCTION |
| REV | PLAY |
| FWD |
| REC | STOP |
| PAUSE |
|
| SWAP | CH |
|
| PIP | CTRL | WHO | |
|
| |||
|
| DELAY | ||
| DSP |
|
| DSP |
| ON•OFF |
|
| MODE |
The backlight button
The up arrow button
3.Press and hold 
(the backlight button) until CODE SET appears in the remote’s display window. Press the OK button.
4.Press the down arrow button to scroll to the desired component (TV, VCR, TAPE, LDP, DAT, DVD, CD, TUNER, AMP, HOME, MISC, PHONO, CAB, SAT VIDEO). In this example, press the down arrow button until VCR appears in the remote control’s display.
5.Use the number buttons on the remote to enter the code for your brand (the Code List starts on page 62). Press OK.
SUCCESS appears in the remote control’s display window when the code is correct.
If NOT FOUND appears in the remote control’s display window, repeat step 5 by entering the next code from the list.
6.To exit, press the CLEAR button (EXIT SETUP appears and the remote is ready to use).
7.Make sure the remote has correctly programmed the desired component (in this example, your VCR): press the VCR button followed by the ON•OFF to see if your VCR turns on. If the component doesn’t turn on, try the following:
•Try again by repeating the previous steps listed. Make sure you’re looking in the correct section of the code list (i.e., you might have the correct brand name, but you might be looking at the wrong type of component).
•Try programming the remote using one of the automatic code search methods (go to page X).
•Use the Learning Feature to transfer the component’s most important functions to your LCOS TV remote control (go to page 45 or 47).
•Review the following notes.
Notes:
•This remote control cannot be programmed to operate some brands of components.
•If approximately 30 seconds passes before a button is pressed, the display window stops transmission to conserve battery life. If this occurs, restart from step 1.
•To exit programming mode, press the CLEAR button at any time (EXIT SETUP appears in the remote’s display to confirm that no new codes have been entered).
49
