RCA L50000 manual Ccontinuesti s on nextt

Chapter 3 The Remote Control

Display window

	DIRECTV	ON•OFF		TV
	VCR			DVD
	1
	VCR			AUX
	2	AUD
	M1			M3
L1, L2, L3		M2
	L1			L3
buttons		L2
				FRONT
	MUTE			SKIP
		CH +
	VOL -			VOL +
	REAR	CH -		CENTER
	FORMAT			GO
				BACK
	TEST			AM•FM
	GUIDE			INFO
The OK	LEVEL -	OK		LEVEL +
button	MENU			CLEAR
	PROGRAM
	1	2		3
	4	5		6
The down	7	8		9
arrow button	INPUT	0		ANT
				FUNCTION
	REV	PLAY		FWD
	REC	STOP		PAUSE
		SWAP	CH
	PIP		CTRL	WHO
		DELAY
	DSP			DSP
	ON•OFF			MODE

The backlight button

Note: Too much light (either natural or fluorescent) might cause the learning feature to fail since the remote controls are passing data via infrared (IR) signals.

7.Repeat steps 5 and 6 to store more functions.

8.When the selected functions are stored press the CLEAR button to exit (EXIT SETUP appears in the remote’s display and the remote returns to original operation mode).

Notes:

•Every time a code is successfully learned, SUCCESS appears in the display.

•Press the CLEAR button at any time to exit the programming mode (EXIT SETUP will appear to confirm that no new codes have been entered).

•If you press a button that can’t be used to learn another function, INVALID appears in the remote’s display.

•The learning capacity is approximately 16 to 25 buttons, depending on the function being learned.

How to Delete a Learning Sequence (L1, L2, and L3 buttons) — IR DELETE

To delete a learned button sequence, either overwrite it with a new button, or use the procedure below.

1.Press and hold (the backlight button) until CODE SET appears in the remote’s display.

2.Step through the programming menu by pressing the down arrow button until IR DELETE appears in the remote’s display, then press the OK button.

3.Press the button to be deleted (L1, L2, L3) on your remote control.

4.If the button is a valid one, the learned data that was stored in the button has now been deleted (DELETED appears in the remote’s display).

ccontinuesti s on nextt page

51