RCA L50000 manual Display Messages response messages

Chapter 3 The Remote Control

Display Messages (response messages)

BAD E2	The remote probably needs serviced or replaced. This message
	indicates that the EEPROM is faulty (the EEPROM is used to store
	the programmed codes, the mode of the remote, learned codes,
	and macros).
DELETED	A requested Learned Sequence was deleted.
END CYCLE	The remote is finished checking all of the codes in its code
	library.
ERROR	Any other error not specifically mentioned.
EXIT SETUP	Escape or exit from the programming mode, or time-out.
INVALID	A wrong button sequence or invalid data.
MAX=15	Notifies you that you’ve exceeded the maximum number of
	button strokes allowed in a Macro Sequence (15).
MEM FAULT	A learned button data storage encounters some error in memory.
MEM FULL	A learned button data storage encounters memory full.
NOT FOUND	A requested setup code not found in the code library.
RESET E2	Indicates the EEPROM reset action has been completed.
RESET RAM	Indicates the RAM reset action has been completed.
SUCCESS	A required task or operation was successful.
UNLOCKED	Message to notify you that the Volume function is unlocked.

42