RCA L50000 manual How to Set the Clock

Chapter 3 The Remote Control

DIRECTV	ON•OFF	TV
VCR		DVD
1
VCR		AUX
2	AUD
M1		M3
	M2
L1		L3
	L2
		FRONT
MUTE		SKIP
	CH +
VOL -		VOL +
REAR	CH -	CENTER
FORMAT		GO
		BACK
TEST		AM•FM
GUIDE		INFO

5.Once you have selected the FROM MODE component, the display message prompts you to enter the TO MODE component. Push the desired component button.

6.When a valid TO MODE component is entered, the remote automatically processes the mode reassignment and SUCCESS appears. The remote will then EXIT SETUP and return to normal operation.

NOTES:

•Press the CLEAR button at any time to exit the programming mode (EXIT SETUP appears and the remote return to normal operation).

•If any button other than a valid component button is entered, INVALID appears and the remote will remain in this FROM MODE or TO MODE programming mode until a valid component is entered.

•If about 30 seconds passes before a button is pressed, the remote’s display window will stop transmission to conserve battery life. If this occurs, restart from step 1.

How to Set the Clock

1.Press and hold (the backlight button) until CODE SET appears in the remote’s display.

2.Step through the programming menu by pressing the down arrow button until CLOCK SET appears in the remote’s display, then press the OK button.

3.After you press the OK button, the remote will display the hours and minutes.

4.Use the up arrow button to modify the hours and the down arrow button to modify the minutes.

NOTE: To set the AM or PM appropriately use the up arrow button and step through the hours for the correct setting.

5.Once the time is set correctly, press the OK button to complete the setup (SUCCESS followed by EXIT SETUP appears).

57