Roland owner manual Memory cards supported by your BR-864, How to remove the card protector

Introduction to the BR-864

Memory cards supported by your BR-864

The BR-864 uses CompactFlash cards as the storage media for recording and playback.

The BR-864 uses 32 MB to 1 GB CompactFlash cards with a 3.3 V power supply.

CompactFlash Type II cards are not compatible.

CompactFlash cards are available at your nearest computer or digital camera shop.

(Recommended Products)

DELKIN DEVICES: eFilm / eFilmPRO Series

CompactFlash products other than those recommended here may not function properly with the BR-864.

Formatting the memory card (CompactFlash)

CompactFlash cards bought at a computer shop, or ones previously used with a digital camera cannot be used as is with the BR-864.

These CompactFlash cards must first be initialized for use with the BR-864.

For more details regarding initializing, see p. 29, p. 149.

*CompactFlash and are trademarks of SanDisk Corpo- ration and licensed by CompactFlash association.

*BOSS Corporation is an authorized licensee of the

CompactFlash™ and CF logo ( ) trademarks.

How to remove the card protector

To prevent theft of the memory card (CompactFlash), the BR- 864 is shipped from the factory with a card protector.

Card Protector

Card Cover

To remove the card protector, use the following procedure.

1.Make sure the card cover is closed, then the BR-864 over.

*When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient the unit so no buttons or controls get damaged.

*When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.

2.Using a coin or

flathead screwdriver, unscrew and remove the coin screw from the bottom panel.

3. Pull out the card cover in the direction indicated by the arrow.

4.To prevent loss of the

card protector after it is removed, place it as shown in the figure.

Insert the card protector in the slot as indicated by the arrow.

5. Turn the BR-864 back over to its original position.

Should you remove the screws, make sure to put them in a safe place out of children’s reach, so there is no chance of them being swallowed accidentally.

16