Roland BR-864 owner manual Erasing data Track Erase, Erasing the repeated portion AB

Editing the performance on a track (Track Editing)

5.Press CURSOR [ ] [ ] and the TIME/VALUE dial to select the track/V-Track to move from, and track/V-

Track to move to.

6.Press [ENTER].

fig.02-338d

7.Use [CURSOR] and the TIME/VALUE dial to specify the time of the beginning of the location “T” (To) where you want the data to be moved.

8.When you are ready to execute the move, press [ENTER]. The display will ask “Are you sure?,” so that you can confirm the operation.

9.Press [ENTER].

Move Event is executed.

10.Press [UTILITY] (or press [EXIT] repeatedly) to return to the Play screen.

*During updating, “Keep power on!” appears in the upper line of the display, while the lower line shows what is being processed.

Erasing data (Track Erase)

Track Erase allows you to erase a specific part of data. Even if data exists after the specified part, it will not be moved forward to fill the gap left by the erasure. Like a normal tape recorder, erasing can be considered covering unwanted data by recording emptiness.

* Do not leave a portion of less than 1.0 seconds in length after
the erased portion. If a portion that short does remain, it will	Section2
end up being silent.
The three types of Track Erase are given below.
Erasing the repeated portion (AB)
Perform the procedure given below to erase the portion from
the repeat start (A) to the repeat end (B).

fig.02-339

Repeat	Repeat	Time
Start (A)	End (B)

1.Press [UTILITY].

2. Press CURSOR [ ] [ ] to move the cursor to “TRK,” and press [ENTER].

fig.02-304d

3. Press CURSOR [ ] [ ] to move the cursor to “ERS,” and press [ENTER].

79