Roland BR-864 owner manual Saving the Mastering Tool Kit settings Write, Section

Mastering

4.Press CURSOR [ ] [ ] to move the cursor to each effect and turn the TIME/VALUE dial to turn each

effect on or off.

Blocks that are turned on are shown in uppercase letters, while blocks that are turned off are shown in lowercase letters. Turn on the effects that you want to use.

5.Press CURSOR [ ] [ ] to move the cursor to the effect with the parameter that you want to change and

press [ENTER].

The Parameter Setting screen for each effect appears.

fig.01-808d

6.Use CURSOR [ ] [ ] to select a parameter, and turn the TIME/VALUE dial to edit the value.

7.If you would like to edit another effect, press [EXIT] to return to the previous screen, and repeat steps 5-6.

8.If you wish to save the current effect settings, perform the procedure described in “Saving mastering tool kit settings,” below.

Edited effect settings are temporary. If you exit the Edit Effect screen without saving the effect patch you changed, “TMP” appears next to the indication of the bank.

Be aware that if you select a new effect patch while “TMP” is displayed, the altered effect patch is returned to its original settings and the changes are lost.

Saving the Mastering Tool Kit settings (Write)

This assigns a name (patch name) to the edited patch settings and saves the settings.

*You cannot write patches while songs are being recorded or played back.

1.Entering the patch name.

*If you do not need to change patch name, go to “4.”

At the Edit Effect screen, press CURSOR [ ] to move the cursor to “NAME,” and press [ENTER].

The Patch Name Setting screen appears.

fig.01-809d

2.Use CURSOR [ ] [ ] and the TIME/VALUE dial to enter the patch name.

* Press [ENTER] to switch between uppercase and lowercase.

3.After you have completed entering the effect settings and patch name as desired, press [EXIT] to return to the Effect screen.

4.Press CURSOR [ ] [ ] to move the cursor to “WRITE,” and press [ENTER].

The Write screen appears.

fig.01-810d

5.Turn the TIME/VALUE dial to select the number to which to write the new patch.

6.After you’ve selected the destination, press [ENTER]. After the save has been completed, you are returned to the Effect screen.

*During updating, “Keep power on!” appears in the upper line of the display, while the lower line shows what is being processed.

Section 1

67