Output Shift

The OUTPUT SHIFT function shifts the entire image (including sidebars) up, down left or right. When you are center- ing the overall image, use output shift. If an image needs to be centered within the sidebars, use INPUT SHIFT (see below).

Input Shift

The INPUT SHIFT function shifts the video signal before it is processed. This is very effective if using a source that either is slightly out of phase or is otherwise off-center in relation to other sources. Examples of this include Satellite TV signals, or the output of a TIVO recorder. (TIVO users may find that a black bar exists on the right side of the image. If so, use INPUT SHIFT to move the image to the right).

IR Code Select

If the remote control loses its 'memory' as a result of weak or dead batteries, it must be re-programmed for the PFP Controller's code set.

To reprogram the remote to the default IR Code Set, press the PROGRAM button followed by 0,1,3. If you have set the Controller for a different Code Set, enter that number instead of 0,1,3.

 

I

Note: Pressing Enter after typing in the code is not necessary.

N

U

 

P

To troubleshoot remote control problems, change the code by access-

T

 

ing the IR Code Set in the Installation Menu.IR Code Set allows the

 

installer to choose from one of four different sets of IR codes. If the

Program Buton

default code has commands that are conflicting other equipment, try

 

using one of the other code sets.

1

When IR CODE SET is selected in the menu, you will get four code set

4

 

options- 013, 215, 510 and 918. These numbers correspond to the

7

number that is programmed into the remote control itself. For example,

 

if you wish to use IR code set 510, you would first select '510 code set'

 

from the menu, then program the remote for code 510 (as described

 

above). You may also disable the IR receiver on the Controller all

 

together by selecting 'Deactivated'. In the event the Controller has

 

been reset, the IR code set will default to 013.

 

'Menu/Enter' invert allows the menu and enter buttons on the remote

 

to reverse their functions; if 'YES' is selected, the menu button will

 

become the enter button, and the enter button will become the menu

 

button. This affects the remote ONLY.

 

PWR

 

I

M

N

P

 

U

 

T

2 3

5 6

89

RUNCO

23

Page 33
Image 33
Runco PL-61CX manual Output Shift, Input Shift, IR Code Select