Runco PL-61CX manual Blanking, System Reset

Blanking

The BLANKING function allows you to 'cut off' part of the image to fit the screen properly, or to eliminate anomalies on the extreme outsides (usually the top) of the image. This can be done to the top, bottom, left or right sides individual- ly.

Blanking
Top	131
Bottom	707
Left	241
Right	1292

To adjust BLANKING, highlight the desired area you wish to blank (top, bottom, left or right), and use the left and right arrows to make the adjustment.

System Reset

In the event that your PL-61cxappears to have a software problem, or adjustments have been made so far out of range that the image is no longer on-screen or discernable, you can reset the processor back to factory values. This sets ALL settings back to factory values, so any adjustments made previously will be lost.

To reset your PL-61cx, follow this procedure:

·Turn off the MAIN POWER switch on the back of the processor

·Hold down the DOWN ARROW button, and turn the MAIN POWER SWITCH back on.Continue holding the down arrow button until the LED on the front panel blinks, then release the down arrow button.

Once this is done, your processor has been completely reset to factory values. After resetting the unit, Composite video will be the active source.

SYSTEM RESET is not on any of the menus; it must be performed using the instructions above.

24