Runco PL-61CX The image appears too, bright, and there is a loss, of definition in the bright

The image appears too	· Contrast is set too high.	· Turn down the CONTRAST
bright, and there is a loss	· The DVD player is set for a	level on the Controller. Mid-
of definition in the bright-	high-level output.	range is -10; it is recom-
est areas of the image.	· The video signal has not	mended to keep it below 0 to
	been terminated properly	prevent this problem.
	somewhere in the system.	· Set the DVD player for a
		nominal output (no boost or
		gain).
		· Ensure all video signals are
		terminated in 75 Ohms.
The image appears too	· Brightness is set too high.	· Turn down the BRIGHT-
'washed out', or the dark-	· The DVD player may be set	NESS level on the Controller.
est areas of the image	for too high of a brightness	If possible, use a PLUGE
appear too bright.	level.	pattern to set the brightness
		level properly.
		· Set the DVD player for a
		nominal output (no boost or
		gain).
The colors of the image	· The Red, Green and/or	· Check the cable connec-
appear abnormal	Blue outputs of the Controller	tions on the back of the
	or inputs to the Plasma are	Controller or on the Plasma.
	reversed.
	· The Pr and Pb inputs on the
	Component input on the
	Controller are reversed
The Plasma will not turn	· The Controller may have	· Unplug the Controller for 2
on, and the power LED on	'locked-up'.	minutes; plug it back in and
the front of the Controller		re-try.
is blinking red or green.		· Perform a system reset on
		the Controller and then re-try.

63