Runco PL-61CX manual Menu Description and Navigation, Menu Tree, Main Menu

Menu Description and Navigation

Menu Tree

INPUT SELECT
Standard Video:
> Composite
S-Video
Component	Brightness
High Definition:	Contrast
Component	Anamorphic
RGB
	Standard 4:3
ASPECT RATIO SELECT	Letterbox
	Virtual Wide
INSTALLER ADJUST*

*Menus are only available during “Installer Mode”.

Tint

Color

Brightness

Contrast

Sharpness

Luma Enhance*

Chroma Enhance*

Color Balance*

Side Bar Level

InvertOff

Output Shift

Input Shift

Blanking

IR Code Select

Red Gain

Green Gain

Blue Gain

Red Offset

Green Offset

Blue Offset

The menu tree above is an overall glance at the menu system in the PL-61cx. The description of the menus and their functions are below.

Main Menu

The main menu includes three main sections: INPUT SELECT (Composite, S-video, Component, HD Component, HD RGB), ASPECT RATIO SELECT and INSTALLER ADJUST.

These menus are described in detail below:

INPUT SELECT is done by highlighting the desired source with the up or down arrows and pressing ENTER. Sources may also be selected by pressing the left or right arrows on the front panel or remote, or by one of the direct access buttons on the remote. High Definition or progressive DVD signals are input to the HDTV port.

ASPECT RATIO SELECT is done by highlighting 'Aspect Ratio' on the main menu and pressing enter. The Aspect Ratio menu will then appear; and either ANAMORPHIC, STANDARD 4:3, LETTERBOX or VIRTUAL WIDE may be selected. Aspect ratios may also be selected by pressing either the up or down arrow buttons, or by one of the direct access buttons on the remote.

INSTALLER ADJUST is used for adjustments usually made during the initial installation. This includes Image Shift, Blanking, Side Bar Level and IR Code Select.

17