Manuals / Runco / Computer Equipment / Computer Monitor

Runco PL-61CX manual PFP Controller Troubleshooting, Problem, Possible Cause, Solution, is pressed

Models: PL-61CX

1 76
Download 76 pages 45.41 Kb
Page 72
Image 72
PFP™ Controller Troubleshooting

PFP™ Controller Troubleshooting

The following is a basic troubleshooting guide that can assist you in resolving typical problems may result in normal operation. If you have encountered problems that are not listed in this guide, please contact your Runco dealer for assistance.

PROBLEM

POSSIBLE CAUSE

SOLUTION

 

 

 

The Plasma does not turn on

· The RJ-11 (ComLink) cable

· Use a standard RJ-11

after initial installation. The

is not connected between the

phone-type cord. Ensure it

Power LED on the front of

Controller and Plasma, or is

is firmly plugged into both

the Controller stays

made improperly.

the Controller and the

yellow after the power button

· The Plasma is not plugged

Plasma.

is pressed.

in, or its AC outlet is not

· Ensure there is good con-

 

active. Look at its power LED

tinuity in the RJ-11 cable.

 

on the front panel.

· Verify that the AC outlet is

 

 

active, or that the Plasma

 

 

is plugged in by turning on

 

 

the main power switch

 

 

located at the rear of the

 

 

unit.

 

 

 

The Plasma and Controller

· The Controller is on the

· Press MENU on the

are both on, but there is no

wrong source.

Plasma's remote, and look

video image on-screen.

· The Controller is on the

to see which source is

 

correct source, but the source

active (the arrow will be

 

itself is off.

pointing to the active

 

 

source). Select the correct

 

 

source as appropriate.

 

 

· Turn on the source. It is

 

 

recommended that all

 

 

sources be turned on first

 

 

before the PL-61cx.

 

 

 

62

Page 71 Page 73
Page 72
Image 72
Runco PL-61CX PFP Controller Troubleshooting, Problem, Possible Cause, Solution, The Plasma does not turn on, is pressed
Page 71 Page 73