getting started

This chapter gives you step-by-step instructions for setting up the USB connected machine and software.

This chapter includes:

 

 

Setting up the hardware

System requirements

Printing a demo page

Installing USB connected machine’s driver

Supplied software

Sharing your machine locally

Setting up the hardware

 

affected.

This section shows the steps to set up the hardware as is explained in the Quick Installation Guide. Make sure you read the Quick Installation Guide first and follow the steps below.

Location

1.Select a stable location.

Select a level, stable place with adequate space for air circulation. Allow extra space to open cover(s) and tray(s).

The area should be well ventilated and away from direct sunlight or sources of heat, cold and humidity. Do not set the machine close to the edge of your desk or table.

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the altitude setting to optimize your printing (See "Altitude adjustment" on page 50).

Place the machine on a flat, stable surface so that there is no incline greater than 2 mm (0.08 inch). Otherwise, printing quality may be

2mm

2mm

(0.08 in)

(0.08 in)

2.Unpack the machine and check all the enclosed items.

3.Remove tape holding the machine securely.

4.Load paper (See "Loading paper in the tray" on page 54).

5.Make sure that all cables are connected to the machine.

6.Turn the machine on (See "Turning on the machine" on page 27).

This machine will not operate when the power main fails.

Printing a demo page

Print a demo page to make sure that the machine is operating correctly.

To print a demo page

In ready mode, press and hold the Cancel ( ) button for 2 seconds, then release. (CLP-325W(K)/CLP-326W only)

Also, you can use the Demo page ( ) button for printing a demo page. This button is supported on CLP-320N(K)/CLP-321N only.

Supplied software

After you have set up your machine and connected it to your computer, you must install the printer software. If you are a Windows or Macintosh OS user, install the software from the supplied CD. If you are a Linux OS user, download the software from the Samsung website (www.samsung.com/printer) and install.

Machine software is occasionally updated for reasons like the release of new operating system and etc. If needed, download the latest version from the Samsung website. (www.samsung.com/printer)

Getting started_ 28

Page 28
Image 28
Samsung CLP-325W, CLP-320 manual Getting started, Setting up the hardware, Printing a demo, Supplied software, Location