Removing the intake grille
Slide the intake grille hooks (2 locations) in the direction of the arrow to open the intake grille. (fig.
When the intake grille is open, press a flathead screwdriver against the rear tabs (2 locations) and pull out the intake grille. (Fig.
A
Removing the side panel
Grasp the finger grip on the side panel and slide the panel in the direction of arrow 1 to remove the panel.
(There are 2 panels: 1 each on the left and right sides.) (Fig.
Screw
Hook
Fig. 3-49a
Hinge
Fig. 3-49b
Screw
Intake grille
Press on the tabs with a flathead (minus)
screwdriver while pulling out the intake grille.
Tab
1Slide
Side panel
Fig. 3-51
(1) | Fasten the hooks on both sides of the ceiling panel |
|
| to the indoor unit. The hooks on one side (2 |
|
| locations) are stationary, while the hook on the other | Stationary hook |
| side is moveable. (Fig. |
|
(2) | Angle the panel somewhat and fasten the stationary |
|
| hook into the fastener on the side of the unit. |
|
(3)After verifying that the hook is fastened, press the other end up until the ceiling panel is level. Then press upwards until the moveable hook is fastened into the fastener on the unit.
(4)Verify that the hooks on both sides of the ceiling panel are securely fastened to the unit. If the hooks are not securely fastened, the panel may fall. At this point, the panel is now provisionally fastened to the unit.
●When removing the panel, press the movable hook toward the inside while supporting the panel.
(Fig.
Fig.
Hook receiver Press to remove.
Moveable hook
Fig.
Moveable hook
Fig.
36